8-50 times longer serving life
4-20 times energy saving
2-5 times space saving
No thermal radiation
Ultra high illumination

500-1600watt UV LED curing Directly replace 1-2K watt Traditional UV Lamp

Wavelength:395-405nm&365-375nm

UV LED curing systems have revolutionized the UV curing industry.

The advantages are obvious: constant light intensity, excellent temperature control, portable and environment-friendly, what's more, a lower procurement cost and almost no maintenance cost.

All these advantages have promoted the use of UV LED products.

Nowadays the UV LED point light source, line light source, area light source are all widely used by related industries.

Weare The world's most high-power LED UV light manufacturer

Focus on area light source LED UV Light.

. We believe that through the joint efforts of the entire industry, UV LED curing industry will have a much better and brighter future!

For a better understanding of UV LED, the following comparison UV LED technology and traditional lamp technology are given and you will easily find the advantagesof UV LED technology.

1.Service life

In tradition, the lamp life is only 800 ~ 3000 hours and then the equipment need to change lamp or repair. However, the lifeof our UV LED curing system can be20000~30000 hours.

 It can be controlled irradiating only when needed, and the time is very accurate and short.

When the operating time equals to the 1/5 preparing time, the service life of UV LED curing system will be30-40 times the service life of lamp equipment.

 By this way we improve your production efficiency and save the energy.

2.Environment-friendly and pollution-free

The traditional equipments use high pressure mercury lamp to irradiate.

There is a large number of mercury in the light bulbs, and it is very troublesome to handle them.

They may cause serious pollution to the environment.

 However, our UV LED curing system uses LED to irradiate; it is environment-friendly and pollution-free.

3.Ultra high illumination

Our UV LED curing systems use High-energy LED chips and Special optical systems, the UV light can achieve high-precision, high-intensity irradiation, and in fact the illumination can be achieved 8600 mW/cm2 .

 The latest optical technology and manufacturing process are used to achieve high-intensity output (more optimized than the mercury lamp irradiation and nearly 2 times the traditional LAMP irradiation light intensity).

Because of this the UV adhesive will curing quickly, and shortens the production cycle, improve production efficiency significantly.

The illumination of single channel will reduce as the channel increase if irradiating by the traditional lamp way.

 However, the LED curing system won't reduce the illumination and all channels can be maintained at maximum.

Because of the high illumination, UV LED curing systems shortened the irradiation time and improve the production efficiency.

4.Energy saving

The irradiation efficiency is more than 10 times of the traditional lamp way.

Their differences are as follows:

LED: nearly none energy consumption during Standby time and you can control the irradiation time

LAMP: high-pressure mercury lamp continuous irradiating regardless of whether Effective irradiation and the most of the energy wasted.

The saving energy of the UV LED can even be calculated as follows:

30000(w)*8(hour)*365(day)= 8760(KWh)

The result means that each UV LED curing system cansave about thousands USD, what's more,it indirectly reduces carbon dioxide emissions about1.4 tons each year and that is to say, a car exhaust in one year.

5.A more flexible installation location that will save space

The size of LED curing system is only 1/5 the size of traditional UV equipment, so it can reduce the total area of the production.

6.High-reliability design

No matter circuit design, optical design, system optimization or the components selection, We  implements a consistent high-reliability design concept, so that we guarantee the stability of the equipment, reliability and consistency of curing.